SL 030 supports the most of known RFID protocols on the frequency of 13.56 MHz like MIFARE 1k, MIFARE 4k, MIFARE Ultralight as well as NFC NTAG203. Built-in antenna and automatic detection of tags significantly simplify usage of the module. Also positive is the fact, that despite a 3V power supply, the outputs are 5V tolerant, thus combination with a 5V logic should be trouble free. SL030 contain besides an I2C communication interface also a direct output (OUT pin) indicating presence of RFID tag in a reach.
SL030 can be set up to 4 different I2C addresses (1010000-1010011) by means jumpers JP1 and JP2. The communication itself runs in a standard form usual for an I2C bus. Commands (from a Host microcontroller of your application) are sent in a form of „Start+Address+Data_Length+Command+Data+Stop“. Overview of available commands is displayed in a Table no. 3. Result of operation is sent back from SL030 through I2C in a form of Command+Status+Data. Byte „Status“ indicates result of operation (Success/Fail,...) - table no. 4. Overview of possible statuses is summarized in section 4-3.