Terminal blocks for DIN rail enable reliable connection of two or more conductors while maintaining maximum order in the distribution box. There are terminals for different conductor diameters and different permitted current loads.
According to the connected conductors’ function, different colours are a matter of course - phase, neutral or protective conductor. The terminals are attached to the DIN rail TS35 or TS15 by a simple snap. Disassembly is also very fast.
Cage Clamp System vs Push-in Cage Clamp
The conductor is attached to the terminal with either the Cage Clamp system or the newer Push-in Cage Clamp without using a screw. Both methods ensure very reliable contact, saving time during installation. The disassembly of the joint is just as fast.
The difference between the two technologies is that to insert the conductor into the CageClamp terminal; it is necessary to "open" the terminal with a screwdriver or similar tool, while when talking about Push-in CageClamp, you need to push the solid or stranded wire with an end sleeve into the terminal. The tool is only required for a stranded wire without a sleeve.
And why should you choose these WAGO screwless terminal blocks? Because they are fast, shock-resistant and, most importantly, maintenance-free. No regular checking - tightening the screws is no longer necessary.
In addition to the DIN rail terminal blocks, we also offer a wide range of accessories - end and intermediate plates, jumper bars, boxes and marking labels.
End and intermediate plates are used to end a series of terminals on a DIN rail safely. The connection jumper bar conductively connects two adjacent terminals. When choosing, pay attention to the correct size according to the size of the terminal block.
Empty boxes allow you to mount your electronics on a DIN rail. Thanks to the marking labels, we will have order and a good overview in the distribution box.
TOP JOB S Series
The most popular Wago terminals are from the TOP JOB S series with the Push-in CageClamp system, which are about 30% smaller than those from the previous generation of TOP JOB with the CageClamp system. But both series have their fans.
The latest additions are the TOP JOB S series terminal blocks either with a lever (series 2102, 2106 and 2116) or a button from the 2200 to 2216 series. The lever eliminates the need for the tool when inserting and removing (it can also be handled with one hand only), and the button increases comfort and visual control when using the tool.
We recommend choosing the 260, 261 and 264 series of terminal blocks when you don’t have bigger space. They have a wide range of mounting options - even on small DIN TS15 rails, on the panel with screws or snap-on feet. It looks good again if you use Wago series terminals with side conductors of the 279, 280, 281 and 282 series in the distribution box.
The list below shows basic types of Wago terminal blocks for DIN rail in our offer, which are immediately available directly from our warehouse. You will find a complete list of DIN rail terminals in our e-shop.
If you need more information about WAGO products or would like advice, do not hesitate to contact us at [email protected].
The TOPJOB®S family, with push-in CAGE CLAMP®, introduced push-in wiring for rail mount terminal blocks. The family now offers levers and push-buttons for convenient and intuitive wire termination while maintaining the vibration-proof, gas-tight, corrosion and thermal-cycling resistant connection.
Do you like our articles? Do not miss any of them! You do not have to worry about anything, we will arrange delivery to you.
